|
|
|
National Stock Number:
5365-01-236-1807
Federal Supply Class:
5365
National Item Identification Number:
012361807
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
| 16611124-001 | 28009 | SYPRIS ELECTRONICS, LLC |
|
Techincal Specification:
| BOLT HOLE QUANTITY | 2 | | BOLT HOLE CENTERLINE TO NEAREST EDGE DISTANCE | 0.209 INCHES MINIMUM AND 0.229 INCHES MAXIMUM | | CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG LENGTH | 0.375 INCHES NOMINAL | | HOLE DIAMETER | 0.138 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | QQ-A-250/11,TEMPER 0 OR T4 OR T6 OR T651 FED SPEC 1ST MATERIAL RESPONSE OR QQ-A-250/8,H32 FED SPEC 2ND MATERIAL RESPONSE | | MATERIAL | ALUMINUM ALLOY 6061 OR ALUMINUM ALLOY 5052 | | PROPRIETARY CHARACTERISTICS | PACS | | OUTSIDE EDGE TO BOLT HOLE CENTER DISTANCE ALONG LENGTH | 0.178 INCHES MINIMUM AND 0.198 INCHES MAXIMUM | | OVERALL LENGTH | 0.750 INCHES NOMINAL | | OVERALL WIDTH | 0.570 INCHES NOMINAL | | SPECIAL FEATURES | HOLES ARE THREADED,0.138-32 UNC-2B; B CORNERS SQUARE,1 CORNER CHAMFERED 0.080 IN. NOM BY 45.0 DEG | | SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | MIL-A-8625,TYPE 2,CLASS 2 MIL SPEC SINGLE TREATMENT RESPONSE | | SURFACE TREATMENT | ANODIZE |
|
|